Lee

4 berth Built for our UK rental operation. Fixed bunks across the rear, outdoor shower and rib double seat/bed

Photos

Features

Drivers Seat
Swivel
Front Passenger Seat
Single Swivel
Rear Seating
Double Seat
Type Of Window
Bonded Fixed
Curtains
Yes
Number Of Windows
2
Front
40x40 mm
Type
Bunks
Quantity
2
Toilet Type
Porta Potti
Outdoor Shower
Yes
Cooking
Combi Unit
Hob
2 Burner
Sink
Combi Unit
Microwave
Yes
Fridge
50 Litres
CBE PC200 control system
Yes
Battery Type
Lead Acid
Number Of Amp Hours
100
USB Sockets
2
240v Sockets
2
LED Lights
6
TV
Yes
Aerial
Yes
Fresh Water Tank
40 Litres
Internal Or External Tank
Internal
Waste Water
20 Litres
Hot Water Boiler
Yes
Type
Gas, Electric
Pump Type
Inline
Type
Standalone
Fuel Type
Gas
Number Of Outlets
2
Reversing Camera
Yes
Reversing Sensors
Yes
Bike Rack
Yes
External Vinyl Graphics
Yes
Awning
Yes
Audio Upgrade
Yes
Insulation, Ply Lining, Carpeting

All of our campers are insulated to the highest standards. We use closed cell 25/50mm foam in the walls and ceiling. Spray foam is used in the cavities and a special underlay is used on the floor to stop any rising cold. We then use 5.5mm CNC cut panels to line the vehicle. We use 18mm marine grade ply on the floor which is then covered in a vinyl of your choice. The walls are finished in a lining carpet material, again in a colour of your choice.

Furniture

Our campers are built using lightweight ply and bamboo. These products are very resistant to wear and due to their lightweight nature lend themselves very well to being using in vehicle furniture construction. All of our furniture is CNC cut in-house and then finished with a hot melt 2mm PVC edge to give a super strong finish.

Design

Every idea is brought to life using Solidworks which is the 3D modelling software we use to design all of our vans. This gives you, the customer, the benefit of seeing the design before we start building. The design process is such that we are customer focused so we can better integrate all aspects of your idea into the final product. Once the 3D model is signed off we then transfer these files to our CNC machine for cutting and final assembly.